Fender Extender Instructions:

Straight Attachment:

Position the extender piece in the desired location.

Check alignment then mark desired hole locations - use the lower 2 holes for attachment as a minimum (top 2 are optional).

Drill holes using a sharp 4mm drill bit suitable for plastic.

Attach Fender Extension using the Fasteners provided but do not overtighten as this may split and distort the part.

 

Note: the part may have a natural curvature so please check this direction and use to you advantage.

Angled Attachment:

If you want the fender-extender to curve slightly, cut through the key-hole section, as shown, and close the gap as required to give the angle you need.